Mikrotron MC13xx Manual de instrucciones descargar pdf (Pagina 15)

5.2.8 Trigger In signal

The trigger input is used to stop a current recording with an external signal.

See Trigger and Synchronisation inputs. The active edge of the signal of pin .. is defined together with

“Trigger edge”.

5.2.9 Enable sync input

For synchronizing camera you only have to connect the sync output of an external source to the sync in-

put, as described in Trigger and Synchronisation inputs

Enabling this mode and applying an external signal will be recognized at the desktop.



The framerate of the external signal must be at least 2 fps less than the camera’s

frame rate, and it must be kept constant during recording!!

5.2.10 Apply the changes

Any changes made in resolution and/or frame rate values will be send to camera after this button is

pressed.Closing the form without using this button first will cause no changes at camera setup.

The changes to other parameters, other then resolution and frame rate, will be applied to camera imme-

diately.

5.3 Arrange a scene

Click on the "Live"-Button to get a live-image from the camera. The camera may now be focused and

aligned for the details of the scene.

5.4 Recording in non circular mode

Non-circular mode is selected in menu "Record" => "record setting" => "non circular..". To start, click

on the red button. Now the camera starts recording and stops when the internal buffer is full. During re-

MotionBLITZ®Kit Manual Ver.2.0 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 50 51

Sin comentarios

Mikrotron MC13xx Manual de instrucciones Pagina 15