Mikrotron EOSENS GE CAMERA Especificaciones descargar pdf (Pagina 9)

Hardware EoSens GE Camera Manual

3 Hardware

3.1 GigE Vision

interface

GigE Vision

is designed for digital cameras in machine vision applications. This interface can

transfer data at a rate of 110 Mbytes/sec.

The GigE Vision

chipset and software is designed and implemented by Pleora Tech. Inc. the

leading supplier of GigE Vision technology. Please refer to the PT1000 documentation for

further information.

3.2 Power supply

The camera needs a DC supply voltage between 8 … 24V at a power consumption of 6 Watt

max.

See also Connector pinning.



Before applying power to the camera we strongly recommend to verify the used

pins of the power connector, the polarity (+/-) of the leads and the supply voltage.

The camera may only be used with a supply voltage according to the camera spe-

cification. Connecting a lower or higher supply voltage, AC voltage, reversal

polarity or using wrong pins of the power connector may damage the camera. If

doing so, the warranty will expire immediately.

3.3 Status LED

A dual color LED on the camera backplane shows the operating condition of the EoSens.

LED orange... The EoSens is configuring the internal FPGA. No other activity is possible.

LED green... The EoSens is fully operational.

LED off... If LED is off, despite the camera is powered, data is stored to the internal

EEPROM. No other activity is possible.

LED red... The microcontroller detected a wrong checksum or the FPGA could not be

loaded because of wrong FPGA configuration data. The camera is not

functional. Try to reload configuration data.

LED red blinking... Data is loaded to microcontroller or FPGA from the PC or the camera

verifies the checksum. No other activity is possible.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Sin comentarios

Mikrotron EOSENS GE CAMERA Especificaciones Pagina 9